ROBBE Futaba R 6007 SP Bedienungsanleitung Seite 12

R 6007 SP 2,4 GHz FASST receiver No. F 0981
The receiver's serial output requires special
modules in the model which are able to read out
and further process the signal chain; these inclu-
de the Mikado Mini-V Stabi or the HC3-Xtreme
No crystals, no spot frequency selection, and
maximum possible security from same-channel
interference: that's 2.4 GHz FASST technology.
High-speed frequency hopping for best possible
suppression of interference signals. High inter-
mediate frequency (IF) of 800 MHz, giving the
system excellent electro-smog rejection. Simple
method of binding using integral EASY-Link but-
ton. Can be used in seven-channel mode with all
FASST transmitters with at least six channels.
Specifications R 6007 SP receiver
Power supply: 3.3-8.5 V(4-5 NC/NiMH)
Current drain: ca. 40 mA
Channel count: 7
Channel spacing: 2048 kHz
Frequency bands: 2.4...2.4835 GHz
Alternatives: 2.4...2.454 GHz
Frequency channels: 36
Transmission system: FSK
Weight: 3 g
Dimensions: 36 x 21 x 7.7 mm
Temperature range: -15...+55°C
Aerial length: ca. 2 cm
Range: ca. 300 m
2
Operating instructions R6007 SP 2.4 GHz receiver
Receiver binding procedure
When you press
the button marked
"Easy Link", the
transmitter's indivi-
dual code number
(130 million codes) is
automatically stored in the receiver. Once "bound"
in this way, the receiver will only respond to the
signals generated by its associated transmitter.
• Place the transmitter and receiver close tog-
ether (approx. 0.5 metres).
• Switch the transmitter on. Activate 7-channel
mode
• Switch the receiver power supply on.
• Locate the Easy Link button on the receiver
and hold it pressed in for at least two seconds,
then release it again to "bind" the receiver to the
transmitter.
• The receiver LED will glow green if the binding
is successful.
This fixed association between the transmitter
and the receiver offers the best possible basis for
suppressing interference signals. It is better than
conventional systems, since a digital filter is used
to filter out only those control signals generated
by the receiver's own transmitter. The net result
is highly effective suppression of interference and
unwanted signals from other transmitters.
Several receivers can be "bound" to the same
module. If you wish to "bind" the receiver to ano-
ther module, simply press the Easy Link button
after switching on.
Receiver LED status indicator
LED red Function/status
LED green
Transmitter signal NOT
OFF ON
received
Transmitter signal recei-
ON OFF
ved
Transmitter signal recei-
flashing OFF ved, but
code number incorrect
alternately flashing Non-recoverable error
Fail-safe settings
The receiver features a fail-safe function which is
present at channel 3 (THROTTLE). A battery fail-
safe function is not supported.
Note:
When setting up the F/S function please be sure
to observe the recommended settings for the
connected devices, such as the HC3-Xtreme or
Mikado Mini V-Stabi.
© robbe Modellsport