Monacor TXA-604/SW Bedienungsanleitung Seite 13

5 Operation
Function
1. Switching the unit
on / off
2. Switching the internal
speakers on / off
3. Volume for a
microphone or audio
unit connected to the
jack MIC / LINE (4)
4. Volume for one or two
wireless microphones
5. Sound for all
microphones and an
audio unit connected to
the jack MIC / LINE (4)
6. Volume for an audio
unit connected to the
jack LINE IN (9)
7. Sound for an audio unit
connected to the jack
LINE IN (9)
Hint: To save battery power, always remember to
switch off the wireless microphones after operation .
5.1 Operation of the receiver module
Each receiver unit (A and B) provides a control (2)
to adjust the volume and to switch it on and off .
The display (1) is divided into two parts: left half
for receiver unit A, right half for receiver unit B .
When a receiver unit has been switched on, the
display will indicate the transmission channel . To
briefly indicate the radio frequency, press the
button  (for unit A) or  (for unit B) .
5.1.1 Setting the transmission channels
Use the controls (2) to switch on the receiver
units . Do not switch on the corresponding trans-
mitter for the time being .
Channel scan
Keep the buttons  and  (3) simultaneously
pressed for approx . 1 second until
on the display . The scan will start: The receiver
units will be set to free channels without mutual
interference . If no free channels are found, the
channels set will be kept .
Operating element
switch POWER (16)
switch INTERNAL
SPEAKER (19)
control LEVEL (5)
control
WIRELESS MIC (6)
controls BASS,
MIDDLE and
TREBLE (7)
control LEVEL (11)
controls BASS and
TREBLE (12)
appears
Manual channel selection
If both receiver units A and B are switched on:
1) Keep the button SET (3) pressed until the
channel indication for receiver unit A starts
flashing on the display .
2) Select the channel for receiver unit A with
the button  or  and then confirm with
the button SET .
3) The channel indication for receiver unit B
starts flashing on the display . Select the chan-
nel for receiver unit B with the button  or
 and then confirm with the button SET .
If only one receiver unit A or B is switched on:
Keep the button SET pressed until the channel
indication starts flashing on the display . Select
the channel with the button  or  and then
confirm with the button SET .
Notes:
1 . The receiver units cannot be set to the same channel .
2 . If a channel is not confirmed within 10 seconds with
the button SET, the setting mode will be exited and
the channel previously set will be kept .
3 . If, with the transmitter switched off, the respec-
tive segment bar A or B on the display indicates
reception, interference signals or signals from other
transmitters are being received . In this case, select a
different channel .
5.1.2 Adjusting the volume
Switch the transmitters on and set them to the
channel of receiver unit A and receiver unit B
respectively . The respective segment bars on
the display will then indicate the strength of the
radio signals received . Use the controls (2) to
adjust the desired volume for each receiver unit .
5.1.3 Setting the squelch
The squelch function will mute the respective
receiver unit when the level of the radio signal
falls below the threshold value adjusted . Thus,
interference signals will not cause noise when
the transmitter is switched off or when its radio
signal is insufficient: If the levels of the interfer-
ence signals are below the threshold value, the
receiver unit will be muted . A high threshold
value offers high interference resistance, but it
will also reduce the transmission range .
1) Switch off the receiver units A and B . Then
keep the button SET (3) pressed while switch-
ing on a receiver unit . The display will indicate
or , with the number flashing .
13