Mounting Parts And Connections; Important Notes - Monacor WALL-05DT Bedienungsanleitung

All mounting parts and connections described can be found on page 2.

1 Mounting Parts and Connections

1 Speaker
2 Locking screws
3 Metal bracket
4 Plastic support
5 RJ45 jack IN / PoE to connect the speaker to the network (Ethernet)
and to supply the speaker with power via the network (e . g . via
a network switch with PoE power supply) . The two LEDs at the
jack indicate connection establishment and data communication .
6 RJ45 jack LINK to route the network connection (e . g . to an addi-
tional WALL-05DT)
The PoE power supply, however, is not routed via this jack . The
two LEDs at the jack indicate connection establishment and data
communication .
7 Power supply jack to connect a 12 V power supply unit as an
alternative to the PoE power supply via the network jack (5)

2 Important Notes

The unit corresponds to all relevant directives of the EU and is therefore
marked with .
• The unit is suitable for indoor use only . Protect it against dripping
water, splash water and high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
• For cleaning only use a dry, soft cloth; never use water or chemicals .
• No guarantee claims for the unit and no liability for any resulting
personal damage or material damage will be accepted if the unit
is used for other purposes than originally intended, if it is not cor-
rectly connected or operated, or if it is not repaired in an expert
way . Likewise, no liability will be accepted for any data loss due
to operating errors or a defect or for any consequential damage
caused by this data loss .
If the unit is to be put out of operation definitively, take it
to a local recycling plant for a disposal which is not harmful
to the environment .
33