Synq DLP-6 Bedienungsanleitung Seite 11

ENGLISH
to unlock it (display on the right appears):
 Turn the DIAL (4) to select a character and press the NEXT button (6) to set the next character, ...
 When the password is entered, press the ENTER button (11) to confirm.
 IF THE PROCESSOR IS NOT LOCKED: you will have 4 different ways to lock the processor:
 Locktype = Modify
All parameters and settings are visible but you can't change them without
introducing a password first. Only the mute switches can be used:
 Turn the DIAL (4) until the display on the right is shown.
 Press the ENTER button (11)  you will be asked to set a password.
 Turn the DIAL (4) to select a character and press the NEXT button (6) to set
the next character, ... (maximum 8 characters – DON'T forget it !!!)
 When the password is entered, press the ENTER button (11) to confirm.
Remark: if you don't want to set a password, simply leave it blank.
 Locktype = Modify & View
You can't see or change parameters and settings without introducing a
password first. Only the mute switches can be used:
 Turn the DIAL (4) until the display on the right is shown.
 Press the ENTER button (11)  you will be asked to set a password.
 Turn the DIAL (4) to select a character and press the NEXT button (6) to set
the next character, ... (maximum 8 characters – DON'T forget it !!!)
 When the password is entered, press the ENTER button (11) to confirm.
Remark: if you don't want to set a password, simply leave it blank.
 Locktype = Modify & Mute
All parameters and settings are visible but you can't change them without
introducing a password first. Also the mute switches are locked:
 Turn the DIAL (4) until the display on the right is shown.
 Press the ENTER button (11)  you will be asked to set a password.
 Turn the DIAL (4) to select a character and press the NEXT button (6 to set
the next character, ... (maximum 8 characters – DON'T forget it !!!)
 When the password is entered, press the ENTER button (11) to confirm.
Remark: if you don't want to set a password, simply leave it blank.
 Locktype = Everything
You can't see or change parameters and settings without introducing a
password first. Also the mute switches are locked:
 Turn the DIAL (4) until the display on the right is shown.
 Press the ENTER button (11)  you will be asked to set a password.
 Turn the DIAL (4) to select a character and press the NEXT button (6) to set
the next character, ... (maximum 8 characters – DON'T forget it !!!)
 When the password is entered, press the ENTER button (11) to confirm.
Remark: if you don't want to set a password, simply leave it blank.
WARNING!  don't forget your password, write it down in a safe place.
MAIN MENU – CONFIG:
In a big setup more than one processor can be used and interconnected with the
RS-485 connections on the rear panel (15). To identify each processor, they all
need a unique device ID.
This is how you can change the device ID:
 Press the DIAL (4) until the first display on the right is shown.
 Press the NEXT button (6) until the display shows "CONFIG"
 Press the ENTER button (11) to enter the submenu.
 Turn the DIAL (4) to change the Device ID number (116, actual ID is marked
with an asterisk "*")
 Press the ENTER button (11) to confirm.
SYNQ
®
The password CANNOT be recovered if forgotten or lost!!!
9/96
OPERATION MANUAL
DLP-6 MK2