Starting And Stopping - Sandrigarden GBL 34 Bedienungsanleitung

GB

6. STARTING AND STOPPING

CAUTION! Strictly heed the warnings
outlined in the chapter 2 above titled
ESSENTIAL SAFETY PRECAUTIONS.
COLD ENGINE STARTUP
1) Press the stop button (fig.26) to the "ON" position.
2) Lift the choke lever located to the right of the
carburettor cover (fig.27) and place it in the
position.
3) Repeatedly press the primer bulb (fig.28) down
until the fuel returns to the tank through the second
transparent hose (fig.29).
4) Grip the handle by pressing the throttle trigger
lock out (fig. 30) with the palm of your hand, thus
allowing you to move throttle control lever (fig.30
item 1) freely.
5) Press the throttle control lever right down (fig.31).
6) Hold the levers (fig.31) down and push the throttle
lock button (fig.32) right down.
7) Hold the button down and release the throttle
control lever.
This should lock the throttle lock button, so both hands
are free to operate the device.
8) Pull the starter grip (fig.33) completely as many
as 3 times.
9) Push the carburettor choke lever (fig.34) down
.
10) Pull the start cord (fig.33) until the engine starts up.
CAUTION - DANGER !! The engine starts
at half acceleration and as a result the line
head is spinning.
Let the engine run a few seconds.
11) Press the throttle contol lever briefly (fig. 35
item1) and the throttle lock button will disengage
automatically. The engine will thus return to idle and
the line head will stop after a short while.
16/
112
BRUSH CUTTERS OPERATING MANUAL
ON
Fig.26
OFF
Fig.28
Fig.30
1
Fig.32
Fig.34
STOP ENGINE
1) To stop the engine, shut the power switch (fig. 35
item 2) "OFF".
Fig.27
Fig.29
Fig.31
Fig.33
Fig.35
2
ON
OFF
1