Sandrigarden GBL 34 Bedienungsanleitung Seite 14

GB
B10.7 DANGER! Do not fit blades
with a diameter greater than 230
mm.
3. DESCRIPTIONS OF MACHINE
PARTS
DESCRIPTION Fig.1
1) Starter grip
2) Starter
3) Chock lever
4) Spark plug cap
5) Fuel cap
6) Silencer
7) Left grip (handle bar)
8) Combustion engine
9) Fuel tank
10) Right handle with controls (handle bar)
11) Rear handle with controls
12) Suspension point
13) Front handle
14) Engine stopping device (OFF/ON swithc).
15) Throttle lock
16) Throttle trigger lock out
17) Throttle control lever
18) Shaft tube
19) Blade
20) Cutting attachment guard (for blade)
21) Cutting attachment guard (for line head)
22) Line head
23) Belt harness
24) Barrier
14/
112
BRUSH CUTTERS OPERATING MANUAL
4. ASSEMBLY
FRONT HANDLE FOR MODEL GBL 26/34
1) Position the handle (item 1) and the guard (item
2) as illustrated in fig.2.
2) Clamp with 4 screws, washers and nuts (fig.3)
The guard is used to maintain a safe distance
between the operator and the cutting tool.
HANDLE FOR MODEL GB 26/34
1) The BRUSH CUTTER is packaged with a folded
handle (fig.4).
2) Loosen the knob (fig.5) and turn the handle
crosswise.
3) Lock the handle by tightening the knob (fig.6) fully.
The handle can be folded back for ease of transport
or storage and can be adjusted for a more
comfortable working position.
BRUSH CUTTERS GB 26/34 and GBL 26/34
may be used:
A. To trim bushes, by fitting the blade and the blade
guard (fig.1 item 19-20).
B. To trim grass by fitting the line head and the
extension (fig.1 item 21-22), that is screwed onto the
same guard.
CAUTION! Safe operating conditions
established by effective regulations
are only met if guards are fitted as
described above.
BLADE AND GUARD ASSEMBLY (fig.7-8)
CAUTION! Wear safety gloves for
assembly and maintenance jobs on the
blade.
1) Fit the two square nuts into their threads on the
guard (fig.9).