Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 28
CAUTION! The line head continues to spin
for a while even after the power switch has
been shut OFF. Hold both handles firmly until the
line head comes to a complete stop.
WARM ENGINE STARTUP
Proceed as with a cold engine startup but with the
choke lever down

7. OPERATION

HOW TO USE THE BRUSH CUTTERS
1) Couple the belt harness (fig.36 item 1) to the ring
(fig.36 item 2).
2) Hold the appliance on the right side as shown in
fig.37-38.
ADJUSTING THE LENGTH OF THE CUTTING
LINE
The line head supplied requires manual adjustment.
Before the cutting line has worn as far as halfway
restore the length by pulling and then turning the
spool (fig.39).
If too much line is pulled out, the length is automatically
adjusted by the limiter blade during rotation.
TRIMMING GRASS
With the line head held parallel to the ground,
proceed swinging the trimmer to the right and left
(fig. 40). Keep the engine running at full speed for a
clean trim.
TRIMMING AROUND OBSTACLES, PLANTS
AND FENCES
Keep the end of the line (fig. 40) just clear of obstacles.
The inclination of the head (fig. 41) may improve
trimming efficiency. Do not knock obstacles with the
line head to avoid cutting lines.
Should lines snap, replace them as outlined below.
BRUSH CUTTERS OPERATING MANUAL
(see fig.34).
8. REPLACING A CUTTING LINE
For rewinding a new line on the original spool:
A) Use a plastic line 2 mm in diameter specially
designed for strimmers.
ATTENTION DANGER! DO NOT USE
METAL WIRE AT ALL! DO THIS JOB
WITH THE ENGINE OFF
B) DETACHING A SPOOL
1) Unscrew the wing nut (fig.42) clockwise.
2) Remove the spool (fig.43-44-45).
3) Thoroughly clean the inside of the housing
(fig.46).
C) WINDING A LINE
1) Prepare two sections of line not over 6 m in
length.
2) Insert the end of the two lines into the 2 holes
(fig.47) provided.
3) Wind the two coupled lengths of line on the spool,
following the direction of the arrow printed on the
spool itself (fig. 48).
4) To make it easier to reinstall the spool in the
housing, attach both ends of the line in the two slots
provided (fig.49).
D) REFITTING A SPOOL
1) Insert both ends through the guiding eyelet
(fig.50).
2) Install the spool and pull boths end of the line
firmly until they hang out of the slots (fig.51).
3) Refit the spring (fig.52) and screw the wing nut
back (fig.53) on anti-clock wise.
GB
17/
112

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gbl 26

Inhaltsverzeichnis