Resolution Function; Notifi Cations - T4W TW-1 Bedienungsanleitung

TW-1/TW-1maxi/TW-1s

Resolution function -

The software of the TW-1 gauge allows to change the measurement resolution.
After selecting this function it is possible to select with the
one of the following resolutions:
• D=10 – the result is rounded up to 10µm, the measurement is faster
• D=1 – the result is accurate to 1µm
While examining the bodywork

4. Notifi cations

WARNING!
happen. In case this happens it is very important NOT TO PRESS ANY BUTTONS.
You should immediately reconnect the battery to reset the device. Pressing any
buttons in the service menu may decalibrate the device's default settings.
You will recognize the service menu by a „Rozn" caption shown on the display
followed by a x-digit number. In this moment You should reconnect the battery!
ATTENTION!
• After decalibration of the device's default settings it is impossible to restore them!
• Restoring the device's default settings can be made only by the producer.
OPERATION MANUAL
Resol.
is a suffi cient option.
D=10
The device has a secured service menu. It is very
difficult to enter this menu, nevertheless it may
If the device is marked with this sign, it means that you can not dispose of it
with household waste. You must hand it to the collection of waste electrical
and electronic equipment recycling. Dispose of used equipment correctly,
you will help to eliminate the threat to the environment and human health.
www.t4w.eu
FUNKTION button
18