Delete Function; Zeroing Function - T4W TW-1 Bedienungsanleitung

www.t4w.eu

Delete function -

Choose this function to delete all measurement values stored in the device's
EEPROM internal memory. After deleting the stored results the device returns
to the main menu automatically.

Zeroing function

Use this function before You start to take measurements. After choosing this
function put the sensor against of the calibration sheet. If the display shows
a 0 +/-10µm value, it means that the gauge is well calibrated. Should the
aberration be larger than 0 +/-10µm, please put
the sensor once more against of the calibration
sheet, wait until the result stabilizes and press the
button while the sensor still touches
OK[MENU]
the sheet. On the display will appear a
caption and the device will return automatically
to the main menu.
If the device is calibrated, You can cancel the
function by pressing the
Zero
button. Please note not to press the
button before the
second line of the display – otherwise the gauge
will decalibrate!.
WARNING!
not place the sheet on the bodywork). Also, please avoid holding the sheet in Your
hands as this may affect the operation..
Please note that zeroing is worth to be made when the measurement conditions
are changing (e.g. the temperature or humidity rises or falls).
17
Delete
caption appears in the
------
While zeroing, the calibration sheet should be
placed on a flat, stable non-metallic surface (e.g. do
OK...
OK[MENU]
OK[MENU]
TW-1/TW-1maxi/TW-1s
OPERATION MANUAL