Blaupunkt SJV701 Bedienungsanleitung Seite 7

SJV701
1. Lid with feeder
2. Vertical screw
3. Extrusion bowl
3a. Filter guides
3b. Switch for closing the juice flow
4. Juice filters (thick, fine filter)
BEFORE FIRST USE
1. Remove all papers, cartons, foil which secure the juicer and juicer parts.
2. Clean the juicer following the advice in Cleaning and Maintenance chapter.
3. It is recommended to assemble and disassemble the juicer before using.
ASSEMBLING THE DEVICE
1. Place the bowl (3) onto the body of the unit (10), and make sure that the three tabs fit into the
holes in the bowl.
2. Insert the selected filter (4) into the guides (3a).
3. Place the horizontal worm (5) in the extrusion bowl so that it fits into the drive.
4. Insert the locking element (6) into the extrusion bowl, taking note of the printed symbols, and
turn clockwise to the closed position.
5. Insert the vertical screw (2) on the top.
6. Place the cover onto the bowl, paying attention to the symbols.
FOOD PREPARATION
Remove stones (plums, peaches, cherries etc).
Remove tough skins (melons, pineapples, cucumbers, potatoes etc).
Soft-skinned and other foods just need washing.
Cut the food into smaller pieces to fit the feed tube.
USING THE DEVICE
To start the juicer, press and hold the On/Off button for 3 seconds. The key lock will be disabled.
Start the juicer with the On/Off button for normal mode, or use the Soft button for pressing soft fruit.
Place fruit or vegetables in the feeder, and slowly push through by pressing the pusher.
Use the "reverse" function only when the screw conveyor is blocked or clearly slows down.
Do not switch the direction of the rotation until the unit has come to a complete stop.
Some very hard foods may make your juicer slow down or stop. If this happens switch off and unblock
the filter.
Insert soft food slowly to get the most juice.
Some fruits and vegetables may block filter during work which cause decrease of the juicing efficiency.
If you observe that during work, efficiency is getting to low, cleaning of filter is needed.
CLEANING AND MAINTENANCE
Warning: The juicer has a rinse-during-operation function, activated between the pressing of various
fruits or vegetables. Close the juice flow (3b), pour some water into the feeder (approx. 0.1-0.2l), and
start the cleaning mode by pressing the "Clean" button. The juicer will perform 6 rotation cycles and
switch off. Open the juice flow.
For easy cleaning - immediately after each use rinse removable parts under running water (to remove
wet pulp). Allow parts to dry.
After disassembling the unit all removable parts may be washed in hot soapy water.
The lid, bowl, pulp container, juice cup are dishwasher safe.
5. Horizontal worm
6. Blocking element with the pulp outlet
7. Juice cup
8. Container for pulp
9. Pusher
10. Body
5