BINZEL-ABICOR ABIROB W300 Betriebsanleitung Seite 41

®
ABIROB W
1 Retaining sleeve
2 Central plug
Fig. 9 Shortening the spiral liner
9.3 Cleaning the torch neck
1
6
5
3 Cable assembly
4 Nut
1 Lay out the hose assembly (3) in stretched position.
2 Disconnect central plug (2) from the feed unit.
3 Screw in support sleeve (1) .
4 Remove the old liner (6) and replace it with a new one and insert the bared
side into the central connector (2) .
5 Place the support sleeve (1) turned by 180° onto the new liner (6) (side
without thread).
6 Cut off the protruding liner (6) flush with the support sleeve (1) .
7 Screw collet chuck (5) onto the spiral liner (6) as far as it will go.
The position of the wire guide can be checked through the sight bore of the
collet chuck (5) .
8 Slide collet chuck (5) and spiral liner (6) into the central plug (2) as far as
they will go.
9 Slide support sleeve (1) on the thread side into the central plug (2) and
tighten it.
10Attach hose assembly (3) to central connector (2) using the nut (4).
In order to increase the system availability of the welding robot, the
ABICOR BINZEL offers the option of automated torch cleaning.
1 Remove gas nozzle.
2 Remove welding spatter and spray gas nozzle with ABICOR BINZEL anti-
spatter agent.
3 Check wear parts for visible damage and replace them, if required.
4 Replace equipment kit when worn or soiled.
9 Maintenance and cleaning
2 3
4
5
6
Collet chuck
Liner
EN - 19