BINZEL-ABICOR ABIROB W300 Betriebsanleitung Seite 40

9 Maintenance and cleaning
9.1 Cleaning the wire guide liner
9.2 Shortening the spiral liner
EN - 18
NOTICE
• The maintenance intervals given are approximate values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Check coolant hoses, seals, and connections for damage and tightness.
Replace as necessary.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
1 Remove adhering welding spatter.
2 Check all screw joints for tight fit.
ABICOR BINZEL offers repair services at the factory.
1 Unscrew the cable assembly on the machine side and bring it into a
stretched position.
2 Unscrew nut and pull out liner.
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide with compressed air, wear suitable
protective clothing, in particular safety goggles.
3 Clean wire feed hose from both sides with compressed air.
4 Slide adjusted liner into wire conduit and secure with nut.
NOTICE
• New still unused liners have to be shortened to the actual length of the
cable assembly.
®
ABIROB W