Inateck BS01001 Bedienungsanleitung Seite 5

2. Enable the Bluetooth of the device to be connected, e.g. PC, cellphone or tablet.
3. You can do that like below.
Windows XP: Click Control Panel->Printers and Other Hardware->Add Bluetooth
Device
Windows 7/8/8.1: Click Control Panel->Add Devices
Windows 10: Click Setting->Devices->Bluetooth
macOS: Click System Preference->Bluetooth
iOS: Click Setting->Bluetooth
android: Click Setting->Bluetooth
4. Enable the Bluetooth on host device and it will automatically search for BS01001.
5. After a few seconds 'Inateck BS01001' will appear in the list of available devices.
Pair the two devices. The blue LED is lit when the scanner is paired successfully.
Wireless Dongle Mode
Dongle refers to the base throughout the instruction manual.
The dongle is paired with the scanner automatically when leaves factory.
1. Connect the wireless dongle to the USB port on your laptop, and the laptop will
begin installing the drive for scanner automatically.
2. Press the power button on the scanner, and the scanner is paired successfully with
the dongle with the blue LED lit.
Note: If you can't upload data via the dongle, please first unplug the dongle from
your laptop, and then scan the "dongle mode" and "Match" barcodes in turn till the
LED flashes green which represents that the scanner is under pairing mode. Then,
plug the dongle into the USB port again when you could hear two beeps from
the scanner with the LED flashing blue. At the time, the dongle has been paired
successfully with the scanner and the scanner is ready for data input. If there's still
a problem, please contact our customer service via support@inateck.com.
Dongle Mode
Match
3