Bell SX840 Bedienungsanleitung Seite 12

EFFECT RETURN R (Mono) / L EFFECT RETURN R (Mono) / L EFFECT RETURN R (Mono) / L
EFFECT RETURN R (Mono) / L EFFECT RETURN R (Mono) / L
Adds external effect signals to Master L/R.
When using external effect units with only one output, use
only the 'R Mono' socket. When using external effect units with
stereo outputs, use both sockets Return L / R.
LED - Indicators LEFT / RIGHT LED - Indicators LEFT / RIGHT
LED - Indicators LEFT / RIGHT LED - Indicators LEFT / RIGHT LED - Indicators LEFT / RIGHT
Monitor the mixer output levels for MASTER L and MASTER R.
D AUX FEATURES D AUX FEATURES D AUX FEATURES
D AUX FEATURES D AUX FEATURES
POWER ROUTING / STEREO (SWITCH 'POWER AMP MODE') POWER ROUTING / STEREO (SWITCH 'POWER AMP MODE') POWER ROUTING / STEREO (SWITCH 'POWER AMP MODE')
POWER ROUTING / STEREO (SWITCH 'POWER AMP MODE') POWER ROUTING / STEREO (SWITCH 'POWER AMP MODE')
The Power Routing system of the SX840 allows the use of the
internal power amplifiers for a) the main speakers (front) or
the monitor speakers.
Normally, the POWER AMP MODE switch will remain in
'STEREO' Position. In this case, the built-in amplifiers will
receive all input signals via the controls L-MASTER and R-
MASTER.
POWER ROUTING / MAIN-MONITOR POWER ROUTING / MAIN-MONITOR POWER ROUTING / MAIN-MONITOR
POWER ROUTING / MAIN-MONITOR POWER ROUTING / MAIN-MONITOR
Setting the power routing switch to 'MAIN-MONITOR' allows
the simultaneous connection of main loudspeakers plus
monitors.
In this mode, the main (FOH) loudspeakers will be connected
to the speaker output socket of AMP1. The monitor
loudspeakers will be connected to the speaker out socket of
AMP2.
Der 'Meter Mode' switch sould be set to MAIN/MON.
Die Master Volume of the MAIN speakers (FOH) will be set via
the MAIN MASTER control.
Die Master Volume of the MAIN speakers (FOH) will be set via
the MONITOR OUT control.
The minimum impedance for each power amplifier is 4Ω!
12