Traffic Message Settings; Audio And Warnings - Porsche Classic Handbuch

Traffic message settings

The recommended route between two locations
can vary. If appropriate data is available, traffic
information can be taken into account in the
route calculation.
You can use this button to switch
the TMC receiver on or off for the
reception of real-time traffic mes-
sages. The following buttons all
relate to the TMC function and are
only available when the receiver is
active.
This setting determines how the
Porsche Classic Radio Navigation
takes the real-time traffic mes-
sages it receives into account
during the route calculation. When
calculating a new route or when a
recalculation is required because
of the traffic messages received,
Porsche Classic Radio Navigation
attempts to bypass the incidents,
as far as practical. You can also
set the delay from which a route
recalculation should be triggered.
If so desired, the application can
also always ask you to confirm a
recalculation.
Touch this button to open the list
of the different types of Event and
to select which of these should
be taken into account in the route
calculation.

Display and settings
Audio and Warnings
Here you can adjust the application sounds and
change the language for the audio instructions.
In addition, you can activate and configure vari-
ous warning messages.
Touch them to adjust the volume
of the different application sounds.
The individual sounds and speech
messages and the associated
control elements will be shown on
a new page. More detailed informa-
tion can be found below.
You can control the volume of the following
sounds and speech messages:
This control changes the volume of
the speech instructions.
You can switch off the ding sound
before a speech message or chan-
ge its volume.
This control changes the volume of
the non-verbal warning sounds (beep
sounds).
Keytones are acoustic signals
triggered when operating device
buttons or the touchscreen. This
control changes the volume of the
keytones.
This switch can mute the audio out-
put. The control becomes inactive.
Touch it once more to reactivate
the volume control.
This button shows the current pro-
file for the Voice Language. Touch
it to select another profile from
the list of available languages and
speakers. Touch on any language
to hear an audio example.
After selecting the spoken language,
simply press the BACK button.
R eal voice: These previously

recorded messages can only give
you basic information about turn-
offs and distances.
In addition, you can select whether
you want to be made aware of more
distant driving manoeuvres or only
upcoming turn-offs.
This button allows you to define how
detailed the speech instructions
should be, i.e. how much should be
said and how often.