General Warnings; Electrical Connections - Stobag SRCK 630 Gebrauchsanleitungen

ENGLISH

GENERAL WARNINGS

fied technician!
The sensor is not a safety device capable of eliminating damage to the awning du
prevent the awning being automatically retracted). The sensor is rather part of an automation capable of protecting the awning and
facilitating its use.
The manufacturer is not responsible for damage due to atmospheric events undetected by the device's sensors.
Do not open the device protection housing as it contains non-serviceable electrical circuits.
Never apply modifications to any part of the device. Operations other than as specified can only cause malfunctions. The
manufacturer declines all liability for damage caused by makeshift modifications to the product.
ever place the device near sources of heat and never expose to naked flames. This may damage it and cause malfunc-
tions.
The product is not intended for use by persons (including children) with reduced physical, sensory or mental capacities,
nor by anyone with insufficient experience or familiarity.
that assures complete disconnection in the conditions of overvoltage category III.
Make sure that the surface of the rain sensor is clean and clear of leaves, snow and other objects: clean it with a soft
damp cloth, do not use alcohol, benzene, solvents or other agents when cleaning it.
This product is a climatic sensor with integral radio transmitter; its other components are indicated in the
guide (Step 1 - fig. A). The sensor is mains powered and is intended for use in automation systems for awnings, shutters,
Product operation is based on real-time readings of variations in wind speed, sunlight intensity and the presence of rain or
snow. When the climatic sensor readings violate their thresholds (either above or below), the sensor transmits a radio signal
sensors can be installed on a single automation system, thus enabling data
26
Any other use is to be considered improper and is strictly prohib-
2 -
of the sensor.
fig. 1
-
wireless headsets, etc.: they can further reduce the range or even block the transmissions of the device to the motor.
Make sure that the sensor's installation zone satisfies the following
(fig. 2) it must allow for full and direct sunlight exposure of the sun sensor surface; never install the product in zones sub-
ject to shade from awnings, trees, balconies etc. or below a source of intense artificial light;
(fig. 3) the area must ensure exposure of the wind sensor blades to the same ventilation as that applied on the sun awn-
ing to be automated.
(fig. 4) it must permit direct exposure of the rain sensor to the rain.
is given in the (Step 1 - phase 1).
Ensure that the surfaces selected for installation are solid and guarantee a stable fixture.
3 -
For installation, fix the various parts of the product in numerical order as shown in the
adjust the sensor body as shown in the
are horizontal ( - Step 1 - phase 18).

4 - ELECTRICAL CONNECTIONS

safety standards and the information provided in this instruction manual.
Make the connections as shown in the
Note
- red > orange > green > red
.
(Step1). Then
(Step 1 - phase 1). Make sure that the wind sensor blades
(Step 1 - phase 10-11-12-13-14).
www.stobag.com
-