Dab Settings; Manual Tuning; Dynamic Range Control - PURE Elan E3 Bedienungsanleitung

DAB settings

Note: You can only see the DAB settings when you have selected 'DAB' as the radio source.
Full scan
You can use the 'Full Scan' (autotune) function to automatically scan for new digital radio stations and
remove inactive ones.
To carry out an autotune:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'Full Scan'. The number of stations found will be
displayed during the autotune.
When the autotune has finished, your Elan E3 will tune to the last station that you were listening to. If the
last station you were listening to is no longer available, your Elan E3 will tune into the first station in the
alphabetical list.

Manual tuning

To manually check the signal strength of a known channel:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'Manual tune'.
3. Turn and press the Select dial to choose the channel.

Dynamic range control

Dynamic Range Control (DRC) is used to make quieter sounds in a digital radio broadcast easier to hear
at low volume or in a noisy environment. Check with the broadcasters to find out if they use DRC.
To change the DRC settings:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'DRC'.
3. Turn and press the Select dial to choose between one of the following options:
DRC high: Applies maximum compression to the DRC level.
DRC low: Applies reduced compression to the DRC level.
DRC off: Removes DRC compression.
EN
15