Wall Unit Mounting - Electrolux EFC 9460 Gebrauchsanweisung

Installation
Wall unit mounting - Fig. 10
Disconnect the hood during electrical connection, by turning the home mains switch off.
Remove the 2 screws fitted inside the lower part of the hood at the points in which it is
fixed to the suction unit (see also operation 3).
• Rest the suction unit on a flat surface and
thread the lower part of the hood onto it
(1).
• Make all the electrical connections
between the two parts (2).
• Fasten the hood to the suction unit using
8 screws (3).
• Sign the wall with a center line, this will
aid mounting procedure (4), position the
template so that the mid line printed on
the template matches with the center
line previously signed, the lower side of
the template corresponds to the lower
side of the hood once mounted (5).
• Drill two holes Ø 8mm and fix the
support bracket with two wall plugs
and screws (6).
• Hang the hood (7) adjust its position
(8-9) and from the inside of the hood
sign one point for definitive fixing
(10), remove the hood (11) and drill
an hole Ø 8mm (12), fit a wall plugs
(13).
• Drill two holes Ø 8mm on the upper
side close to the ceilling (14), fit
two wall plugs and fix the chimney
support with two screws (15).
• Hang the hood again (16).
• Fix it definitively with a screw
(17). To simplify the mounting
operation remove the carbon
filter frame.
• In case the hood is to be used in
filter version, mount the deflector
F on the chimney support G with four
screws 2,9x6,5 and fit an exhausting pipe
(18) to connect deflector to the outlet hole D of
the hood.
In case the hood is to be used in exhausting version,
then the deflector must not be mounted and fit an
exhausting pipe (18) to connect outlet hole D of the hood to the outside.
• Make electrical connection (13), but leave the hood disconnected from the home
general electric panel.
• Fix the chimney (16a) to the chimney support (16b).
Slide down the lower section on the proper housing on top of the hood. Connect the hood
the the home general electric panel and check if the hood work properly.
G
20a
F
2
2
1
1
Fig. 10
44
20a
H
20b
G
7-16
11
18
19
9
D
8
8
9
8
13
17
3
14
15
20b
4
11
6
5
12
10