Installation
Mounting accessories included
4 screws 5 x 45 mm
4 wall plugs Ø 8 mm
4 screws 4,2 x 35 mm
1 flange Ø 125 mm
1 allen spanner (for TORX screws)
1 screw 2.9 x 13
Wall unit mounting
•
Make the holes on the bottom of the cupboard
(2), using the drilling template (1).
Provide an hole also for exhausting pipe (4)
ONLY if is decided to use the hood in
Exhausting version (3).
•
From inside the cupboard, insert the 4 supplied
screws (5) and tighten them in the appropriate
holes on the appliance.
Wall mounting
• Sign a centerline onto the wall (1).
Fit the template onto the wall (2).
• Fix the drilling template to the wall.
• Make 3 Ø 8mm holes in the wall (3), 2 at upper
points, 1 as desired at lower points.
• Insert the three Ø 8mm expansion plugs into the
wall (4).
• Insert 2 5x45 screws (5) but do not tighten them
completely, hang the hood (6).
• Adjust the unit so that it is positioned at a right
angle to the wall by turning the two screws on
lower side (7).
• Tighten the 2 upper screws (8).
• From inside the hood, insert the third 5x45
screw into the lower hole (9) and tighten (10).
Fig. 8 - Wall unit mounting
1
3
4
3
4
5
2
Fig. 9 - Wall mounting
41
http://www.markabolt.hu
1
2
3
5
5
5
5
4
1 c
m
5!
5
6
4
8
7
6
9
7
8
10