Control Panel - Efc 9415; Control Device For Grease And Charcoal Filters - Electrolux EFC 9460 Gebrauchsanweisung

Control Panel - EFC 9415

• Best results are obtained by using a low speed for normal conditions and a high speed when odours are more
concentrated.
Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen.
The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The
control switches are located on the unit's front panel:
A - Main switch, hood off.
B - Start and choice of motor speed 1-2-3-1-
2.........
C - Indicates speed 1 (LED).
D - Indicates speed 2 and saturation of the
grease filter (LED)
E - Indicates speed 3 and saturation of the
charcoal filter (LED) (flashing LED)
F - Indicates Intensive speed (LED).
G - Intensive speed on/off. The Intensive
speed runs for 5 minutes:
If the hood is on when the Intensive speed
is activated, the hood reverts to previous
speed after 5 minutes.
If the hood is off when the Intensive
speed is activated, the hood will be turned
off after 5 minutes.
To interrupt the Intensive speed, press
button A or B.
H - Light OFF
I - Light ON
Should the hood or the controls fail to operate:
disconnect the power supply for at least 5 seconds,
then turn the hood back on again.
Control device for grease and
charcoal filters
This hood is fitted with a device that signals when it
is necessary to clean the grease filter or the
charcoal filter (in the case of recirculation version
with charcoal filter).
On delivery, the hood is not supplied with an
charcoal filter, so the saturation indicator will be
disabled.
If the hood is to be used with a charcoal filter, the
saturation
A B C D E F G
Bild 4
indicator light must be enabled as follows:
Press buttons B and G simultaneously and hold
them for 3 seconds. At first only the grease filter
LED D will light up, but when the charcoal filter
LED E lights up the saturation indicator will be
enabled.
To disable it: Press buttons B and G again
simultaneously and hold
them for 3 seconds, until the charcoal filter LED
goes out.
Grease filter LED (D)
LED D will start to flash when it is time to clean
the grease filter.
Cleaning will be necessary after 40 working hours.
Always comply with the maintenance instructions
for the grease filter.
Charcoal filter LED (E)
The charcoal filter LED E will start to flash when
the charcoal filter needs to be replaced.
This operation is necessary after approximately 160
working hours.
Correct ventilation
If the cooker hood is to work correctly there must
be an under pressure in the kitchen. It is important
to keep the kitchen windows closed and have a
window in an adjacent room open.
37
H I