Herunterladen Inhalt Inhalt Diese Seite drucken

General Safety Instructions - Pentair Water SW series Wartungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 9
Ch. 1 - Features
Ch. 2 - Limitations
Ch. 3 - Installation
Warnings for the safety of individuals and objects.
Carefully follow the instructions marked with the following symbols.
DANGER
Electric shock
risk
DANGER
WARNING
WARNING: Read this manual carefully before installing this pump. Any damage caused by failure to
observe the directions contained in this manual will not be covered by warranty.
CH. 1 FEATURES
Series SW comprises single-bloc centrifugal pumps, without self-priming device, with front suction, radial delivery,
one stage and peripheral impeller. Every pump is carefully tested and packed during its assembly. On receiving the
pump, verify that the product complies with the requirements stated in the order and that it has not been damaged
during transportation. All damages should be immediately reported to the dealer by and no later than 8 (eight) days
from the date of purchase. Avoid dispersing and/or disposing the packing in the environment, to allow it to be recycled
and collected in special waste disposal areas.
CH. 2 LIMITATIONS
SW series pumps are suitable to pump chlorinated water from swimming pools. All the components in contact with the
water come in man-made polymer, which offers a double electric insulation and full anti-oxidising properties.
WARNING
WARNING
MAX. TEMPERATURE OF PUMPED LIQUID
MAXIMUM/MINIMUM AMBIENT TEMPERATURE
MAXIMUM SUCTION HEIGHT (recommended)
MAXIMUM OPERATING PRESSURE
CH. 3 INSTALLATION
DANGER
Electric shock
risk
WARNING
All SW pumps are self-priming. If the pump is used to suck water, it is advisable to install it as close as possible to
the source. All pumps should be installed in a ventilated area to ensure sufficient air for cooling purposes. Suction
pipes should be air-sealed and show no signs of bends and/or counter slopes to avoid the formation of air locks that
could impair the regular operation of the pump. Pumps installed below the water level should be insulated from the
system. It is advisable to fit an on-off valve both on the delivery and suction side.
CONTENTS

GENERAL SAFETY INSTRUCTIONS

Warns that the failure to follow the directions given may cause
electric shock.
Warns that the failure to follow the directions given could cause
serious risk to individuals or objects.
Warns that the failure to follow the directions given could damage
the pump or the system.
The pump cannot be used to move inflammable or dangerous
liquids.
Verify that the pump never runs without liquids.
When installing, please ensure pump is disconnected from
electrical supply.
Protect the pump and all pipes from bad weather or freezing
conditions.
Ch. 4 - Electrical connections
Ch. 5 - Starting the unit
Ch. 6 - Maintenance and troubleshooting
40° C
45° C
3 m (with foot valve)
2,5 bar
GB
3

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sw 33

Inhaltsverzeichnis