IDEXX SNAP Pro Kurzanleitung Seite 4

Setting up the analyzer
1
Open the battery compartment
on the back of the analyzer
and then place two batteries
(provided), negative end first,
into the compartment.
2
Connect the appropriate adapter for your
region to the power cord using these steps:
a. Remove the protective insert
while sliding the locking key
toward the cord.
North America
Japan
b. Insert the adapter top-side
first and then snap into place.
Australia United Kingdom
3
Europe
South America
5
1
4
3
Connect the power cord to the
analyzer and an appropriate
electrical outlet. The status light
should appear steady yellow.
Note: It will take up to 8 hours
to fully charge the analyzer (the
status light will turn green when
fully charged). The analyzer may
be used while charging.