Safety Guidelines; Care And Maintenance - Hamax Outback Benutzerhandbuch

EN
User Manual jogger kit
Congratulations on purchasing the Jogger kit. This manual is additional to the Hamax Outback Multifunctional Child Carrier user
manual. Please read the instructions carefully before assembling or using the Hamax Outback. We wish you and your children
many enjoyable trips!
REMARK: Please see the main user manual (Hamax Outback 2 in 1) for details. Should you no longer have the main manual,
this can be downloaded from www.hamax.com
Keep these instructions in a safe place for later use.
Please register your product here: www.hamax.com/product-registration

SAFETY GUIDELINES

WARNINGS
!
• Important – Keep these instructions for future reference
• This product complies to the European and American standards for child bicycle trailers and
strollers (EN 15918, EN 1888, ASTM F1975 and ASTM F833).
• FALL HAZARD from tip over. Before running, jogging or walking fast, a separate jogging wheel must
be mounted.
• FALL HAZARD - Wheel can detach and cause tip over. Pull on wheel to assure it is securely
attached.
• Ensure that all the locking devices are engaged before use.
• Always use the wrist strap when using the jogger.
• Always test the hand brake after installation before using the jogger.
• The hand brake can be used to reduce the speed of the vehicle, not suitable for a direct full stop.
GETTING STARTED - INSTALLATION
[1] Packaging content & required tools
• Jogger kit (1x) [1a]
• Safety strap (1x) [1b]
• User manual jogger kit (1x)
Attaching and removing the jogger wheel
Attaching and removing the jogger wheel is done similar to the bicycle arm. Please see the main manual for details.
[2] Mounting the hand brake
• You can select if you want the hand brake mounted for the left or right hand.
• Guide the cable through the 4 velcro cable straps [2e]. The brake cable should always be guided through the right side of the
trailer.
• Place the hand brake [2b] over the push bar (space in the middle) and attach the hand brake by using the hand screw [2a].
Attaching the wrist strap
• Fold the wrist strap around the push bar [2c].
• Pull the loop at the end of the wrist strap through the glide buckle [2d] on the other end and pull the strap tight.

CARE AND MAINTENANCE

Storage
TIP: Use the storage strap [1c] for optimal storage of the Jogger kit.
[3] [4] Maintenance
• Adjusting the brake cable: If the brake is not functioning properly when using the hand brake you can adjust the brake cable
length at the hand brake knob [3a] and/or at the caliper knob [3d]. Are you in doubt, please contact your local dealer for
assistance.
p. 7