BOMANN KB 6012 CB Bedienungsanleitung Seite 35

Unpacking the Appliance
1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".
Scope of Delivery
1 Cooler box
1 Power cord for alternating current (AC) 220 – 240 Volt
1 Car power cord for direct current (DC) 12 Volt
Notes for Use
General Notes
• Never place the appliance next to naked flames or other
heat sources.
• The lid is locked when the handle is pushed back and
when carrying.
• To open the cooler box, pull the handle forward.
• Do not open the lid more often than required. Do not
leave the lid open more often than is necessary. This will
influence the duration of the cooling or keeping warm.
• The duration of the cooling or keeping warm is also
dependent on the ambient temperature.
• The appliance is not suitable for permanent operation.
• The appliance can be connected to two different energy
sources.
- Alternating current: 220 – 240 V~ or
- Direct current: 12 V
• Use the switches COLD – OFF – HOT and ECO – NOR-
MAL to switch the appliance on and off, or select an op-
eration mode. Both switches must be switched on in the
desired position to ensure the function of the appliance.
• The respective indicator lamp will indicate the mode:
- Green for cooling
- Red for keeping warm
• Do not switch directly from one operating mode into the
other. If you would like to change the operating mode,
turn the appliance off. Wait about 30 minutes before you
switch it to the other operating mode.
Cooling
• You may keep cold foods cold for several hours.
• Turn the switch to the COLD position.
• The green control lamp lights up.
KB6012CB_IM
• For best results, only store already cooled food / bever-
ages in the cooler. Select a place of use that is protected
from direct sunlight.
Keeping Warm
• You may keep hot food / beverages warm for several
hours.
• Set the switch to the HOT position.
• The Peltier element will switch off and on at intervals to
maintain the temperature. The red control light will be lit
up when the Peltier element is in operation and when
the fan is running.
• The appliance is not designed for reheating. Cold food
will only warm up slightly after about 2 hours.
ECO or NORMAL?
In order to operate the appliance in energy-efficient mode,
use the setting ECO.
NOTE:
• You may only use the appliance with the function ECO
when connecting it to alternating current 220 – 240 V.
• The output is reduced in the operating mode ECO.
Use this operating mode when there are smaller loads
in the cooler box, for example.
Using the Appliance
Make sure the appliance is switched off. The switch
COLD – OFF – HOT must be set to OFF.
Connection to the Alternating Current
1. Remove the power cord for the direct current, if nec-
essary.
2. Check to make sure that the mains voltage that you
want to use is 220 – 240 V~.
3. Plug the power cord for alternating current into the " ~ "
socket on the appliance (see fig.)
4. Connect the appliance to a properly installed earthed
socket.
5. Set the switch to ECO or NORMAL.
6. Set the COLD – OFF – HOT switch to COLD for cooling
or to HOT for keeping warm.
Connection to the Direct Current
1. Remove the power cord for the alternating current, if
necessary.
2. Turn on the engine of the motor vehicle.
35
19.11.18