Vermeiren Carpo 3 Gebrauchsanweisung Seite 21

Carpo 4:
DISMANTLING
1. Remove the cover cap for scooter rim.
2. Unscrew and remove the middle screw that attach the wheel and flange to the scooter.
3. Let the air out of the wheel by lightly pressing the pressure pin on the valve.
4. Unscrew the 4 screws of the rim to separate the rim sides and flange.
ASSEMBLY
Insert the partly-filled inner tube into the tyre.
1. Connect the two sides of the rim through the tyres and place the flange against the tyre and screw
them back again with the 4 screws.
2. Put the air valve through the hole for it in the rim.
3. Put the wheel and flange back on the scooter and secure these connection with the middle screw.
Inflate the wheel to the recommended tyre pressure.
4. Replace the cover cap.
Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of the
rim on both sides of the tyre, then the tyre is centered properly. If not - let out the air and position the
tyre afresh. Now the tyre can be inflated to its full operating pressure (note the maximum) and the
valve cap should be replaced.
Only an expert can guarantee correct assembly. Work not done by your specialist dealer, would void
any warranty claims.
When inflating the tyres, always check that the pressure is correct. The correct pressure is given on
the tyre walls.
Use only inflating equipment which complies with regulations and indicates the pressure in bar. We do
not accept any liability for damage caused by using inflation equipment not supplied by the
manufacturer.
DISASSEMBLING & ASSEMBLING
The chassis – situated below the seat and arm rests – can also be taken apart. Proceed as follows:

Switch the scooter off

Remove the seat (see "Seat" chapter).

Lift off the rear plastic cover (held in place by Velcro fasteners).
L
Bear in mind that the cables of the rear lights are connected to the plastic cover. Unplug the
plugs before entirely removing the plastic cover.

Unplug all battery plugs (not the pole connectors) and all cable plug- and socket connections.

Loosen the straps used to fasten the batteries in place.

Lift the batteries out.
Instruction manual Carpo 3 / Carpo 4
Last updated: 2018-07
I
8