Dmx Linking - Chauvet Professional STRIKE Saber Schnellanleitung

AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Replacing the Fuse
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

DMX Linking

The STRIKE Saber will work with a DMX controller using a 5-pin DMX data connection. A DMX Primer is available from
www.chauvetprofessional.com.
DMX Connection
The STRIKE Saber uses a 5-pin DMX data connection for its DMX personalities: 1Ch, 3Ch, 7Ch, 11Ch, 20Ch, and 27Ch.
See the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The STRIKE Saber uses the DMX data connection for its Master/Slave mode. See the User Manual for information about
connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The STRIKE Saber supports RDM protocol that allows feedback to monitor changes to DMX
Address, DMX Channel, Dimmer Mode, and LED Frequency menu options. Download the User Manual from
www.chauvetprofessional.com
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting
clamps, go to http://trusst.com/products.
Floor Stand
The STRIKE Saber comes with a Floor Stand which can be installed with the included screws.
Mounting Diagram
Overhead Mounting
Safety Cable
Secure the safety
cable using the
passageway on
the back of the
product
STRIKE Saber QRG Rev. 3
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
for more details.
Safety Notes. Use at least one mounting point per product. Make sure the
Wire (Europe)
Brown
Blue
Green/Yellow
Mounting Clamp
EN
Screw Color
Yellow/Brass
Silver
Green
2