Ferm ETM1005 Übersetzung Der Originalbetriebsanleitung Seite 6

Loading the tacker
Before opening the tool, make sure the
tool is switched off.
To load the tacker
Fig. 3 - 4
Replacing staples
• P ress the slide unlock (2) to unlock the slide.
• P ull the slide out of the machine
• P lace the staples (fig. 4) in the cartridge
• P ush the slide back in the machine.
• L ock the slide by sliding the slide forward until
it locks into place.
Using the tacker
• P ress the On/Off switch (1) to switch the
machine on
• P ress the On/Off switch (1) to switch the
machine off.
• P lace the tool on workpiece at the spot where
the staple should be located.
• P ress the tool down firmly.
• P ress the switch (4).
The tool will cause a re bound because of
the force it operates with. Keep this in
mind.
4. MAInTEnAnCE
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
This machine has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
• I n case a staple is jammed in the tool, follow
the procedure below
• S witch off the tool
6
• C arefully remove the staple from the tool
with a thin object (for example a knife).
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Cleaning
Regularly clean the device's casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove tough dirt using a
soft cloth, dampened with soapy water. Do not
use solvents such as benzene, alcohol, ammonia,
etc., which might damage the plastic parts.
defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is an
exploded view of the parts that can be ordered.