Technical Data - Tack life PID01A Bedienungsanleitung

Care of the Tools
Overload
Never use excessive force when drilling. Too much pressure reduces the speed of the
machine, and the required power is greatly reduced. This may result in overlo
which can damage the motor of the drilling machine. When the drilling machine
becomes too hot, allow it to run for two minutes without a load and then interrupt
working for a short time. Clean the drilling machine with a clean cloth and a brush.
Ensure that the ventilati on slits are not blocked.
Warning: Always use the additional grips which come with the appliance. Losing
control of the appliance may result in injuries.

Technical Data

Voltage:
Frequency:
Power input:
No load speed:
Chuck size:
Drilling capacity:
Steel:
Concrete:
Wood:
230V~
50Hz
650W
0-2600/min
13mm
10mm
13mm
25mm
- 06 -
ad,
120V~
60Hz
6A
0-2800rpm