Special Safety Information - Tack life PID01A Bedienungsanleitung

Special Safety Information

When drilling or screwing into walls, ceilings etc make sure beforehand that you will not
damage any hidden electric cables. During this work you should not touch any metal
parts of the machine. Only touch the machine by the plastic housing.
Your machine is double insulated. This means that two completely independent types
of insulation prevent you from coming into contact with live metal parts. This measure
represents a high degree of protection against an electric shock.
Your Drill has the following Functions:
The operating switch (6) is used for all work carried out with the drilling machine. With
the speed selection via the regulator wheel you have optimum control of the
machine.
The machine can be set to continuous operation with the locking button (5).
The second handle (2) gives you an additional way of holding the machine firmly.
Depending on the position of the percussion drilling/drilling switch(3), you can use
your drilling machine as a percussion drill or rotating drill.
The direction switch (4) controls the direction of motion when the machine is used
as a screwdriver or if you would like to remove a drilling bit that has become jammed.
Using the adjustable bit stop you can fix the depth of blind holes accurately during
drilling.
Preparing the Drilling Machine
Warning! When performing the following work, always ensure that the machine is
not connected to the mains power supply
Inserting the Second Handle (2)
In order to assemble the second handle (2), release it by rotating the lower part
anti-clockwise so that you can easily pull the handle over the drill chuck on to the
flange located behind it. Then turn the handle to a working position that is comfort-
able for you and fix it in place by tightening it (rotating the lower part clockwise).
Adjusting the Bit Stop
The second handle (2) has a retainer for the bit stop. Insert a drill. Now release the
handle. Push the bit stop forwards until its end is in line with the end of the drill. Now
push the bit stop back until the distance between the end of the bit stop and the end
of the drill corresponds to the depth to which you would like to drill.
- 04 -