Tack life PID01A Bedienungsanleitung Seite 7

Inserting the Drill
First remove the mains supply from the socket. Turn the ring of the drill chuck (1) until
the clamping jaws are open wide enough. Insert the drill into the clamping jaws of the
drill chuck (1). Insert the end of the drill chuck key (7) into one of the three holes on the
body of the drill chuck (1) and let the head of the key (7) lock into place in the ring of
the drill chuck (1). In order to tighten the clamping jaws and fix the drill in place, turn
the drill chuck key (7) in a clockwise direction. Important: Then remove the key (7) from
the chuck (1)!
Working with the Drilling Machine
Ensure that the mains power supply voltage is the same as the operating voltage of
your machine. For details, please see the type plate. Insert the correct drill for the type
of job to be performed. If necessary, adjust the bit stop. Adjust the speed of the
machine using the regulating wheel on the operating switch (6). The more the
operating switch (6) is pressed in, the faster the drill rota tes. Set the direction switch
(4) to the desired direction of motion. Never alter the position of the percussion drilling
switch (3) or the direction switch (4) when the machine is switched on. The machine is
switched on by pressing the operating switch (6). When the operating switch (6) is
released, the machine stops. If you would like to use continuous operation press the
locking button (5) while the opera ting switch (6) is pressed. In order to switch off the
machine during continuous ope ration, press the operating switch (6) again and then
let it go. Do not touch the drill chuck (1) while the machine is switched on.
Drilling Tips
● Always insert the correct size and type of drill or screwdriver.
● Set the machine to the correct speed.
● Always hold the machine tightly by the handle and second handle (2).
● When drilling wood and metal, set the percussion-drilling switch (3) to drilling.
● When drilling masonry, set the percussion-drilling switch (3) to percussion drilling.
●
When using the machine as a screwdriver, set the percussion-drilling switch (3) to
drilling.
●
Set the direction switch (4) to the correct direction.
●
Never change the direction of motion when the machine is switched on.
- 05 -