Special Safety Instructions - Tack life PES01A Bedienungsanleitung

Read the Operating Instructions carefully before use
General safety instructions
NOTE: Read all warnings, safety instructions and other directives. Failure to follow all the instructions
and safety instructions can result in electric shock, fire and/or serious personal injury.
●
Keep the work area clean and well lit.
●
Do not use power tools in the rain or in damp areas.
●
Avoid body contact with earthed surfaces such as pipes, radiators, cookers and refrigerators.
There is an increased risk of electric shock if your body is earthed. Hold the tool by the insulated
grips when working in areas where bits or attachments may come into contact with concealed cables.
●
Keep children and onlookers at a safe distance when using power tools.
●
Store power tools out of the reach of children in a dry, dust-free location when not in use.
●
Use the power tool only for its intended purpose.
●
Wear appropriate clothing. Loose-fitting clothing, jewellery and long hair can get caught in moving
parts. Wear a hair net if you have long hair.
●
Wear protective gloves.
●
Wear eye protection. Wear a dust mask if the work generates dust.
●
Be careful with the power cord. Never use the cord to carry or pull the tool or to pull out the plug
from the mains socket.
●
Keep the power cord away from heat, oil and sharp edges. A damaged power cord must be replaced
by an authorised service centre, or other qualified person, to avoid putting safety at risk.
●
Secure the workpiece with a clamp, vice or clips.
●
Never touch the tool's moving parts until they have come to a complete standstill.
●
Always maintain a firm footing and good balance.
●
Do not use the power tool if its power cord or plug are damaged, if a malfunction has occurred
or if the tool has been damaged in any way.
●
Install bits and other accessories correctly on the power tool.
●
Unplug the power cord before performing maintenance and/or cleaning and when the power tool
is not in use.
●
Make sure the power switch is in the OFF position before plugging in the cord.
●
If using the machine outdoors, only use an extension cord approved for outdoor use.
●
Check that the tool is in good condition before use. Make sure that moving parts are properly
adjusted and do not jam and that no parts are incorrectly fitted or damaged. Check for other
factors that could affect the operation of the power tool. Do not use the tool if it is damaged. The
tool must be repaired by a qualified service centre.
●
At low temperatures and if the power tool has not been used for an extended period, you should
allow the tool to operate with no load for a few minutes before use, in order to distribute the lubricant.
●
Clean the tool with a cloth moistened with water and mild detergent. Do not use strong or abrasive
detergents or solvents.
●
Wear ear protection.
●
The tool is a class II electrical appliance, double insulated to provide protection against electric
shock, and is powered by a single-phase motor.

Special safety instructions

●
Check that the mains voltage corresponds to the rated voltage on the type plate.
SAFETY INSTRUCTIONS
- 01 -