patura P20 Bedienungsanleitung Seite 37

Requirements for electric animal fences
(in accordance with Annex BB, section BB.1 of EN 60335-2-76)
Electric animal fences and their ancillary equipment shall be installed, operated
and maintained in a manner that minimises danger to persons, animals or their
surroundings.
Electric animal fence constructions that are likely to lead to the entanglement of
animals or persons shall be avoided.
WARNING! Avoid contacting electric fence wires especially with the head,
neck or torso. Do not climb over, through or under a multi-wire electric fence.
Use a gate or a specially designed crossing point.
An electric animal fence shall not be supplied from two separate energizers or
from independent fence circuits of the same energizer.
For any two separate electric animal fences, each supplied from a separate
energizer independently timed, the distance between the wires of the two electric
animal fences shall be at least 2.5 m (8'). If this gap is to be closed, this shall be
effected by means of electrically non-conductive material or an isolated metal
barrier.
Barbed wire or razor wire shall not be electrified by an energizer.
A non-electrified fence incorporating barbed wire or razor wire may be used
to support one or more off-set electrified wires of an electric animal fence. The
supporting devices for the electrified wires shall be constructed so as to ensure
that these wires are positioned at a minimum distance of 150 mm (6") from the
vertical plane of the non-electrified wires. The barbed wire and razor wire shall be
earthed at regular intervals.
37