Getting Started; Detaching The Front Panel; Resetting The Unit; Setting The Clock - Sony CDX-G1302U Bedienungsanleitung

Getting Started

Detaching the Front Panel

You can detach the front panel of this unit to
prevent theft.
1 Press and hold OFF  until the unit
turns off, press the front panel
release button , then pull the panel
towards you to remove.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.
Attaching the front panel

Resetting the Unit

Before operating the unit for the first time,
after replacing the car battery, or changing
the connections, you must reset the unit.
1
Press DSPL and EQ for more than
2 seconds.
Note
Resetting the unit will erase the clock setting and
some stored contents.
Setting the area/region
After resetting the unit, the area/region
setting display appears.
1
Press ENTER while [SET AREA] is
displayed.
The area/region currently set appears.
2
Rotate the control dial to select
[EUROPE] or [RUSSIA], then press it.
3
Rotate the control dial to select [YES]
or [NO], then press it.
If the setting area/region is changed, the
unit is reset, then the clock is displayed.
This setting can be configured in the general
setup menu (page 12).

Setting the Clock

1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [SET
CLOCK], then press it.
3
Rotate the control dial to select
[MANUAL], then press it.
The hour indication flashes.
4
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
/ (SEEK –/+).
5
After setting the minute, press MENU.
The setup is complete and the clock
starts.
To display the clock
Press DSPL.
To set the clock automatically
Select [AUTO <RDS>] in step 3.
7
GB