Cocraft 18-3600 Bedienungsanleitung Seite 8

1. Make sure that the vacuum is unplugged from the mains.
2. Lift the motor unit and fit the foam filter onto the motor. Refit the motor unit back
onto the container and make sure that the latch is securely fastened.
3. Attach the vacuum hose to the vacuum port and twist it clockwise until it locks
into place.
4. Attach the appropriate accessory.
5. Plug the mains lead into a wall socket.
6. Start the vacuum with the power switch.
7. Empty the container when it becomes full.
Things to consider when wet vacuuming
• The cloth dust filter and dust bag must first be removed and the foam filter fitted,
before beginning any type of wet vacuuming.
• Make sure that the foam filter is clean and dry before wet vacuuming.
• A safety float valve regulates the water level within the container. When the
container needs to be emptied, the motor will start to race. Turn off the motor with
the power switch, lift off the motor unit and empty the container.
• Refit the motor unit back onto the container and continue work as usual.
• Clean the foam filter regularly. Remove the foam filter and hand wash it with water
and a little mild detergent. Allow the filter to air dry.
• Wipe the container clean and allow it to dry before storing the vacuum or
continuing with any type of dry vacuuming.
• Don't forget to fit the cloth filter and dust bag before beginning any type of dry
vacuuming.
Blower function
The blower function is used to clear the hose of any lodged foreign objects or debris.
You may be forced to clean the hose manually if any lodged objects or debris have not
been cleared after a few seconds of using the blower function.
Warning: Use respiratory protection and protective eyewear. Keep children and pets
at a safe distance while the vacuum is in use.
1
1. Make sure that the vacuum is unplugged from the mains.
2. Connect the vacuum hose to the blower port (17).
3. Plug the mains lead into a wall socket.
4. Start the vacuum with the power switch.
2 3
8
4