Batteries Installation - Chal-Tec Klarfit 10009110 Bedienungsanleitung

1. Batteries Installation

Please install 2 pieces of AA 1.5V batteries in the battery case on the back of monitor.
(Whenever Batteries are removed, all the functions values will be reset to zero.)
2. Auto On/Off
While the user starts to do exercise, the Display will show out the workout value automatically. Once
stop exercising over 256 sec, the Display will turn off. But the workout value of odometer will be hold.
While user starts exercise again, workout value of odometer will accumulate continuously.
3. Auto Scan
After the monitor is power on or press Mode key, the LCD will display all functions values from Time-
Calories-Odometer- Pulse- Speed- Distance. Each value will be held for 6 seconds.
4. Speed
Display the current training speed from 0.0 to 99.9 KPH or MPH.
5. Distance
Accumulates total distance from 0.0 up to 999.9. The user may preset target time by pressing SET &
MODE button. Each increment is 0.1 KM or M; each increment will be 1 KM or M when distance is over
100. Automatically count down from targeting value during exercise.
6. Time
Accumulates total time from 00:00 up to 99:59. The user may preset target time by pressing SET &
MODE button. Each increment is 1 minute.
Automatically count down from targeting value during exercise.
7. Calories
Accumulates calories consumption during training from 0 to max. 9999 calories. The user may also preset
the target calorie before training by press SET & MODE
1000; each increment will be 10 Cal when calories is over 1000.
Automatically count down from targeting value during exercise.
Note: This data is a rough guide which cannot be used in medical treatment.
8. Odometer
Display the total accumulated distance from 0.0 to 999.9. User also can press mode key to display the
Odometer value.
9. Pulse
The monitor will display the user's heart rate in beats per minute during training.
10. Reset
Press the button and hold for 2 seconds to reset all value except Odometer to be zero.
Note:
1. If the computer displays abnormally, please re-install the battery and try again.
2. Battery Spec: 1.5V UM-3 or AA (2PCS).
3. The batteries must be removed from the appliance before it is scrapped and that they are disposed of
safely.
FUNCTIONS & OPERATIONS
button. Each setting increase is 1 Cal till