Key; General; Safety; Responsibility - DAB AQUATWIN TOP 132 Installationsanweisung Und Wartung

1. KEY

In this document the following symbols will be used to avoid situations of ranger:
Situation of general danger. Failure to respect the instructions that follow may cause harm
to persons and property.
Situation of electric shock hazard. Failure to respect the instructions that follow may cause
a situation of grave risk for personal safety.

2. GENERAL

Read this documentation carefully before installation.
Installation, electrical connection and commissioning must be carried out by specialised personnel, in
compliance with the general and local safety regulations in force in the country in which the product is
installed. Failure to respect these instructions not only causes risk to personal safety and damage to the
equipment, but invalidates every right to assistance under guarantee.
The appliance is not intended to be used by persons (including children) with reduced physical, sensory or
mental capacities, or who lack experience or knowledge, unless, through the mediation of a person
responsible for their safety, they have had the benefit of supervision or of instructions on the use of the
appliance. Children must be supervised to ensure that they do not play with the appliance.
Ensure that the product has not suffered any damage during transport or storage.
Check that the outer casing is unbroken and in excellent conditions.
The user is responsible for all that concerns the use of the system (electrical, hydraulic systems etc...) in
accordance with the local safety and installation regulations in force. A qualified electrician must ensure that
the required safety measures are present before the system is started. The installation of a I∆n=30mA circuit
breaker on the electrical system is compulsory prior to its use. Check that the voltage of the mains power
supply corresponds to the power supply required by the system. The indications specified on the rating plate
must correspond to those of the electrical system. Do not lift or move the system with the power supply
cable. Check that the power supply cable and plug are intact. Avoid that the power supply plug and the
system itself are subjected to flooding or direct jets of water. In the event of faults, repair must be carried out
by authorised workshops only and only original spare parts must be used.
We wish to emphasise that we shall not be held responsible for damage caused by:
a) unsuitable repair carried out by unauthorised technicians
b) replacement with non original spare parts
these indications are also valid for the accessories
2.1

Safety

Use is allowed only if the electric system is in possession of safety precautions in accordance with the
regulations in force in the country where the product is installed.
2.2

Responsibility

The Manufacturer does not vouch for correct operation of the machine or answer for any damage that it
may cause if it has been tampered with, modified and/or run outside the recommended work range or in
contrast with other indications given in this manual.
ENGLISH
32