Coati 12600 Bedienungsanweisung Seite 15

2º manual 12600.qxd 30/11/00 17:46
5. ADJUSTING PROGRAMS
Program Blocks
The thermostat has two program blocks (weekdays and weekends), with four programs in each
block. The programs are preset as follows:
WEEKDAY BLOCK
Starting Time
Program1 6:30 am.
Program 2 8:00 am.
Program 3 4:30 pm.
Programa 4 11:00 pm.
This table indicates the time and temperature for each program. The programs turn the heat on and off at
the specified times in order to maintain the indicated temperatures. Program times and temperatures may
be reprogrammed according to your individual needs and preferences. Normally programs 1 and 3 turn
the heater on, and are set at a comfortable room temperature. Prorams 2 and 4 usually turn off the heat,
and are set for a fairly low room temperature. These can be reversed, however, with programs 2 and 4
maintaining a higher temperature, and 1 and 3 maintaining a lower temperature.
Página 28
WEEKEND BLOCK
Temperature Starting Time Temperature
20 °C
Program 1 8:00 am.
14 °C
Program 2 10:00 am.
20 °C
Program 3 7:00 pm.
15 °C
Program 4 11:30 pm.
28
Example:
• Suppose we get up each morning at 7:30 am. We can set Program 1 to begin at 7:00 in order
to heat the house to 22° C. (provided we are in the house).
• Suppose we leave the house at 9:30 am. We can set Program 2 to begin at that time, in order
to maintain the house at 15° C. (given that we are not going to be there).
• We return home at around 7:30 pm. We can set Program 3 to begin at 7:00 in order to raise
the indoor temperature to a comfortable 22°-23° C.
20 °C
• At 11:00 pm. we can set Program 4 to lower the room temperature again to 14° C.
14 °C
20 °C
Therefore, the general programming schedule for weekdays would be:
15 °C
Program 1: from 7:00 a 9:29 am, 22° C
Program 2: from 9:30 am to 6:59 pm, 15° C
Program 3: from 6:00 pm to 10:59 pm, 23° C
Program 4: from 11:00 pm to 6:59 am, 14° C
To set program times and temperature, procede as follows:
29