Coati 12600 Bedienungsanweisung Seite 13

2º manual 12600.qxd 30/11/00 17:46
Note: Bear in mind that most furnaces have their own thermostat. Remove the connecting bridge
between the furnace and the old thermostat, and connect the furnace to the cables leading directly
to the chronothermostat. For greater safety, however, consult the manual for your particular
heating system beforehand.
9. Again line up the new thermostat with the hole for the first screw. Open the front cover, and
fit the screw into the plug located behind the battery compartment.
10. Once the thermostat is mounted and connected, procede to reconnect the main electrical
line from the household main switch.
Inserting Batteries
The cronothermostat operates with 1'5 V AA batteries, preferably alcaline. The batteries must be
inserted in the battery compartment of the thermostat.
When inserting the batteries for the first time, the screen should show the proper time, date, and
room temperature, as shown in the drawing below.
Página 24
If the informatoin displayed on the screen is not correct, press the "erase" key, using a pointed
object, such as a paper clip.
After inserting the batteries, close the front cover of the thermostat.
3. PROGRAMMING TIME AND DAY
To program the time, follow the steps below:
1. Hold down the "HOUR" key until the two dots on the clock stop blinking.
2. Press the "HOUR" key to set the correct hour.
3. Once the hour is correctly set, press the "MIN" key to the correct time.
4. To set the days of the week, press the "DAY" key to read the correct day. Days are
designated as follows:
SUN= Sunday TUE=Tuesday
MON= Monday WED= Wednesday
5. Lastly, press the "ENTER" key to return to the standard operating mode. The two dots on the
clock will again start blinking.
25
THU= Thursday SAT= Saturday
FRI= Friday