Coati 12600 Bedienungsanweisung Seite 12

2º manual 12600.qxd 30/11/00 17:46
3. Heat from the sun or household appliances
4. Built-in pipes or chimneys
It is advisable to install your thermostat in a frequently used room, such as the living room or dining
room.
Mounting the cronothermostat on the wall
Remember to disconnect the electrical main from the central swtich before taking out the old
thermostat and installing the new one.
1. Before placing the batteries, make a hole in the wall, making sure that the thermostat cable
terminals are properly aligned.
2. Next, place one of the plastic plugs provided with the thermostat into the hole. Make sure
that the plug is flush with the wall.
3. Fit one of the screws provided into the plug.
4.On the back of the thermostat, there is a hole on the right side. With the back of the
thermostat facing the wall, line up the hole on the thermostat with the screw on the wall,
moving the thermostat toward the left until it fits into the guide.
Página 22
22
5. Open the front cover of thermostat. In the battery compartment there is a second hole for
mounting the thermostat. Mark on the wall the location for the second screw, making sure
that it is in line with the first screw, and remove the thermostat.
6. Make a hole where you put your mark, and place another plastic plug, again ensuring that
the plug is flush with the wall.
7. Mount the thermostat on the wall and connect the cables to the terminals as shown in the
following diagram. If you have any questions or concerns, call our customer service number.
8. The terminals are found on the back of the thermostat. Only two cables are needed to
connect the thermostat to the heater. Connect the cables as follows:
Connecet cables L and N to the furnace as shown in the diagram. Connect two additional cables
between the furnace and the new thermostat, as indicated in the diagram on your furnace. Never
connect the L and N cables directly to the cronothermostat.
23