Coati 12600 Bedienungsanweisung Seite 14

2º manual 12600.qxd 30/11/00 17:46
4. REGULATING THERMOSTAT
The thermostat can be regulated in various ways.
Regulating Temperature Differential
The temperature differential refers to the difference between actual room temperature and
thermostat's programmed temperature. The temperature differential can be set between 0'2° C and
3° C. To set the temperature differential:
1. Press the "ENTER" key for at least two seconds until you see on the screen "1.2° C SWING".
2. Use the triangular key to change the differential.
3. To set the differential and return to the standard operating mode, again press the "ENTER"
key.
Adjusting Temperature Gauge
Occasionally the chronothermostat can not be installed in the same room whose temperature you
wish to control. For example, you may wish to control the temperature in the dining room, and the
thermostat is located in another room. To compensate for the difference in temperature between
Página 26
26
the two rooms, the thermostat gauge needs to be modified between -5° C and +5° C, depending on
the temperature difference existing between the two rooms.
1. Press the "REG/MAN" key twice and hold down until you see on your screen CL O.
2. Use the triangular buttons to set the correct temperature.
3. To program the temperature and return to the standard operating mode, press ENTER.
Maintaing Constant Temperature
In cases where you are absent from the home for extended periods, the thermostat can set and
maintain your home at a contstant temperature. This temperature is usually very low. To set the
temperature:
1. Press the "REG/MAN" key once. The word HOLD will appear blinking on the screen.
2. Using the triangular buttons, select desired temperature.
3. To program temperature, now press "ENTER". The word HOLD (not blinking) will again
appear on the screen.
To return to standard operating mode, press ENTER.
27