Modster Hanno Prettner Curare 60 EP/GP ARF Bauanleitung Seite 5

Hanno Prettner Curare 60 EP/GP ARF
Notes:
This assembling instruction is designed in such a way that text is deliberately omitted and instead many indivi-
dual pictures are displayed. The curare 60 is designed for experienced modelers, therefore, individual assembling
segments such as the correct handling with adhesives, attaching the servos, the correct assembly of the receiver,
receiver battery, switch cable and / or BEC assembling block, gluing of the rudder hinges, assembly of rudder
linkages, security of screws, the soldering of soldering sleeves, etc. are not described in detail.
Please have a look at the assembling instruction precisely before you start assely, if you do not feel yourself in the
position to complete the model properly, ask an experienced modeler for his help or in case of doubt you return
the model to its dealer in the original condition!
Furthermore you find this assembling instruction with highly enlarged photos, under the following link:
http://www.der-schweighofer.at/artikel/91651 > PDF Manual download
Security: You acquire a flight model kit with which you will create a remote control model capable of flight from
the contents of the kit and suitable accessories. Please note that this model is not a toy! If you have no experience
with the handling of such models, ask an experienced colleague for assistance. Remote controlled aircraft models
are not a toy, always keep in mind during the completion , you alone are responsible for the safe operation of your
model. You could endanger yourself or others in their health.
Please check the kit before starting assembly for completeness or for possible damages and read this manual
thoroughly. You will find an overview of all assembling components at the end of this manual. Complaints of pos-
sible damaged parts can not be accepted after the start of assemling.
Note: The appearance of wrinkles or bubbles in the covering film are no reason for complaint, this can occur due
to different temperature / humidity during storage or on the transportation route. The solution for the removal is
easy. For this, slightly warm the corresponding place with iron foil or a hair dryer and rub carefully with a soft
cloth.
Attention! Proceed very carefully and warm up the corresponding place only as much as it is absolutely necessary.
Too much heating may damage the film!
Liability / responsibility: Since the proper compliance of this assembly instructions and the careful handling of
the model can not be controlled and monitored, the seller accepts no liability for losses, damages and costs that
can arise on completion and operation of this model. The obligation of seller for the payment of compensation
for damages of any kind, as well as direct and indirect consequential damages that can arise from the use of this
model is in principle excluded . The total responsibility is limited to the value of this kit.
Important: Before the operation of this model aircraft resulted from the present model kit, take an appropriate
liability insurance. Each model club located in your vicinity will help you with pleasure.
(Modelsport Schweighofer offers an appropriate liability insurance for model makers within the European Union.)
www.modster.at
5