Rear Panel Layout - Samson Resolv Se6 Anleitung

Rear Panel Layout

1. HF LEVEL – Four-position rotary switch used to adjust the high frequency
response. Setting the switch to 0dB (factory setting) produces a flat response.
The -2dB, +2dB and +4dB adjusts a high frequency shelf above 4kHz. Your
room acoustics or listening material will determine the appropriate setting for
your application.
2. VOLUME – Controls the amount of overall output level.
3. XLR Input (SE6 and SE8 only) – Connect a balanced, +4dBu, line level signal here
via standard XLR (microphone) cable.
4. ¼" Input – Connect a balanced, +4dBu, line level signal here via a TRS (Tip,
Ring, Sleeve), or unbalanced TS (Tip, Sleeve) ¼"cable.
5. RCA Input – Used to connect signals from unbalanced, –10dBV devices.
6. POWER Switch – Use this switch to turn the speakers on and off. When powered
on, the front panel LED will light.
7. Voltage Switch – Used to select the operating voltage.
NOTE: Be sure to check that the voltage setting and fuse rating are correct for your country.
AC Inlet – Connect the supplied IEC power cable here.
8.
9. Fuse Holder – Holds the mains fuse. To replace the fuse, remove the power cable
and pry the fuse holder open using a flat head screwdriver.
NOTE: Never remove the fuse while the speakers are plugged in.
10