Safety Instructions; Connection And Operation; Oven; Before Using The Appliance For The First Time - Teka HM 830 Gebrauchs- Und Montageanweisung

Safety instructions

Connection and operation

The appliances may only be connected to the mains, maintained and
repaired by a qualified electrician according to valid safety regulations. Work
carried out incorrectly places your safety at risk.
Do not put the appliance into operation unless it has been built in!
The surface of the oven is very hot when in operation. Always keep children
away!
Make sure connection cables for electrical devices are not jammed in the
oven door.
Steam and/or pressure cleaning machines must not be used to clean the
oven! This can damage the unit resulting in risk of personal injury.
The appliance is to be used only for the preparation of food in the home.

Oven

When carrying out repairs the appliance must be disconnected from the
mains (switch off the fuse or unplug from the mains).
Never store any objects in your oven which could cause a hazard if the oven
is unintentionally switched on.
Take special care when working in the hot oven. Use a dish cloth, oven
gloves or similar.
Be careful opening the door when the oven is hot: don't lean over the open
door straight away. As soon as you open the door, hot air and even steam
will emerge through the door opening.
The oven door must close well. In the event of damage to the door sealing,
hinges, sealing surfaces or to the glass pane, do not use the appliance until
it has been repaired and checked by a qualified person.
Attention! When opening and closing the oven door, do not reach into the
hinge. Risk of injury!
Always close the oven door completely when preparing food in the oven.
Keep it at a distance of at least 5 cm from the grill and top heat.
If the oven door is to get less hot (e.g. when you have little children in your
household), the Customer service can offer you a solution under the spare
part No. 564 000.
16
Before using the appliance for
the first time

Setting the clock

The oven will not function until the clock is set.
The clock must be set before the oven is used and whenever power has been
disconnected to the appliance. If the clock is not set, a dash flashes in the
bottom right-hand corner of the display.
– Set the time you want with "+" and "-". The
clock starts after a few seconds and the
flashing dash disappears.

Initial cleaning

– Remove foreign matter and packaging.
Dispose of the transport packaging in such a way that it does not
impact on the environment.
– Before preparing food for the first time, the appliance must be cleaned.
Clean the baking trays, drip pan, gridiron etc. with a damp cloth and a little
detergent.
– Heating the oven.
Close the oven door.
Heat up the oven with Top/Bottom heat at 250 °C for 60 minutes.
Air the kitchen well at the same time.
HM 830