English; Package Contents; Description (Fig. A); Electrical Safety - DeWalt DE0245 Bedienungsanleitung

E N G L I S H
• Never attempt to open a battery pack for any
reason.
• Use only chargers labelled "NiMH" or "NiMH +
NiCd" to charge D WALT NiMH battery packs.
E
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Battery charging
Battery charged
Problem charging
Charges only NiCd battery packs
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Do not expose to water
Have defective cords replaced
immediately
Charge only between 4 °C and 40 °C
See technical data for charging time
en - 2
DE0245.PM5

Package contents

The package contains:
1 Battery charger
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your DE0245 charger accepts D
battery packs only.
1 Charger
2 Charging indicator (red)
3 Battery pack
4 Refresh mode button

Electrical safety

Make sure that the voltage of your charger
corresponds to that of your mains.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 3 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
14
Refresh mode
E
Your D WALT charger is double
E
insulated in accordance with EN 50144;
therefore no earth wire is required.
WALT repair agent or a qualified electrician.
21-02-2001, 11:33
WALT NiCd
11