Herunterladen Inhalt Inhalt Diese Seite drucken

Transmitter And Receiver Binding; Troubleshooting Guide - Blade Red Bull BO-105 CBCX Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Red Bull BO-105 CBCX:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Transmitter and Receiver Binding

CX
The Red Bull BO-105 CB
the receiver the specifi c code of the transmitter, so it will only communicate with your transmitter. There should be
no need to bind the transmitter and receiver prior to use. If you ever need to re-bind the transmitter and receiver,
please follow the steps below.
Binding Procedure:
1. Disconnect the fl ight battery from the helicopter.
2. Power off the transmitter.
3. Connect the fl ight battery in the helicopter. The onboard control
unit LED fl ashes rapidly after 5 seconds.
4. Lower the throttle stick to the lowest position. Then, press in and
hold the right stick while powering on the transmitter.
5. Release the right stick after 2–3 seconds. The helicopter is bound
when both heli and transmitter LEDs are solid.
6. Disconnect the fl ight battery and power the transmitter off.

Troubleshooting Guide

Problem
Helicopter throttle will not
respond
Rotor blades will not turn
Motor power decreases
during flight
Climb rate is greatly reduced
Helicopter vibrates or shakes
in fl ight
Helicopter climbouts are
slow and/or nose turns while
climbing/descending
uses 2.4GHz radio frequency band and requires a "binding" procedure. Binding teaches
Possible Cause
Throttle at high position
Low battery voltage
Receiver uses default soft Low
Voltage Cutoff (LVC)
Low battery voltage
Damaged rotor blades or fl ybar
Rotor drive gears are dirty, have
hair in them, etc
Lower the throttle stick to off for
3 seconds
Completely recharge fl ight battery
Recharge flight battery or replace battery
that is no longer performing
Recharge fl ight battery. Replace AA bat-
teries in the transmitter/charger. Replace
the fl ight battery if necessary
Check the main rotor blades and fl ybar
for cracks or chips. Replace all damaged
parts. Always replace rotor blades as a
pair and always select blades from the
same package.
Clean the rotor gearing with a dry tooth-
brush and remove any dust or hair that
may have accumulated
9
Solution
EN

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Blh2800

Inhaltsverzeichnis