Blade Red Bull BO-105 CBCX Bedienungsanleitung Seite 8

How to be a Successful Pilot
• Read the instruction manual carefully (especially the Troubleshooting section if you're having problems).
• Small, smooth control inputs are best. Quickly moving the stick just produces instability and no real fl ight
control.
• Make sure the fl ight battery is fully charged before each fl ight. It's better to run the fl ight battery down to
50% or lower before recharging. A good, fully charged battery should be good for approximately 4
minutes of fl ight time. If your fl ight time falls below 2 minutes, your battery may need to be replaced.
• Keep the helicopter dry and clean. Carpet lint, pet hair, dirt, etc, can restrict the motor and controls, giving
reduced power and control response times.
• Failure to Bind—Hold the transmitter 2-3 meters away from the helicopter while binding. Trying to bind
while the transmitter is too close to the helicopter can sometimes cause problems.
• Make sure the canopy is connected to all four mounting posts. A loose canopy will cause the helicopter to
shake.
• The helicopter must be sitting motionless to initialize the gyro stabilization system after connecting the fl ight
battery. If you are holding the helicopter in your hand or moving it around, it may not initialize properly. There
should be no reason to disconnect the battery and start again. Just put the helicopter down on the landing
skids and it will initialize in a few seconds.
• Make sure that the stabilizer/fl ybar is free to teeter up and down. This is what stabilizes the top rotor
system. If the stabilizer/fl ybar is restricted, your Red Bull helicopter will not fl y correctly.
Advanced Flight Controls
Your Blade helicopter features optional advanced fl ight controls
(High Rates). High Rates make the helicopter more responsive to
your control inputs.
To activate High Rates, turn on your included transmitter and fi rmly
push in on the right control stick until you hear a fast two-beep
tone. Release the control stick. A slowly blinking red power LED on
the transmitter indicates High Rate mode is activated. Transmitter
will return to regular (low) rate automatically when switched off.
To switch back to low rates, push in on the right control stick
again until you hear the fast two-beep tone. Release the stick and
confi rm that the red power LED is solid.
Aft er Flying
Remove the fl ight battery immediately after
fl ight and fully charge before storing.
EN
1
2
8
Power off the transmitter.
3