Mounting The Monitor; Functionality Test; Monitor Settings - Eufab 16256 Anleitung

6.2.6 Mounting the monitor

Insert the monitor fixture of the monitor holder,
position 10 in the overview, see Figure 7, in the
recess on the back of the monitor. Slide the
monitor completely on the fixture, until the lock
engages. Insert the angle plug of the monitor
connection cable, item 2 in the overview, in the
connection socket of the monitor, Figure 8.
Fasten the monitor with the holder on the windscreen of your vehicle,
as shown in Figures 9 and 10.

6.2.7 Functionality test

Plug the camera cable and the cable of the transmitter together. Switch on the ignition of your vehicle. Insert the plug of the
monitor cable into the 12 V socket of your vehicle. If the installation has been correctly done, a blue indicator light in the left
top of the frame of the monitor lights up. Now engage reverse gear. If the transmitter and camera are connected correctly the
monitor displays an image. If no image can be seen, proceed according to the fault table in Section 6.5 and correct the fault.
If you have not detected any fault, turn off the ignition and disconnect the plug of the monitor cable. Lay and fasten the cable.
Replace all the lining parts in the boot and in the passenger compartment.

6.3 Monitor settings

There are four buttons on the top of the monitor. Figure 11.
12 ON/OFF button
13 + button
14 Menu button
15 - button
To turn the monitor on and off press button 12. The screen menu is
activated by pressing the menu button 14. Continuing to press the
menu button further switches from menu point to menu point. The
settings for each menu point can be made with the + and – buttons.
To leave the screen menu, select „EXIT" by continuing to press the
menu key and then press the + or – button.
Suction
foot
Tab
Fixing nut
Clamping lever
Figure 11: Monitor operation
Figure 12: Screen menu
Monitor fixture
Lock
Figure 7: Monitor holder
Anschlussbuchse
13