Connecting The Camera; Connecting The Camera On Vehicles With Can; Bus Or Data Bus System; Mounting The Monitor - Eufab 16256 Bedienungsanleitung

6.2.6 CONNECTING THE CAMERA

Select a suitable installation location for the transmitter, item 11
in the overview. Here it is possibly necessary to remove parts of the
lining in the boot or in the passenger compartment of the vehicle.
The installation location must not be too far removed from the
camera and the rear light, pay attention to the cable lengths. In
addition the transmitter must be placed as close as possible to the
receiver (monitor), without metallic components, body metal, ribs
and reinforcements being able to negatively infl uence the radio
transmission. Fasten the transmitter, e.g. with cable ties. Lay the cable
so that it cannot be bent, pinched or stretched.
CAUTION
For the next step, working on the electrical system of
the vehicle, it is necessary to unclamp the battery. This
could cause, for example, the radio code, data of the
on-board computer or other settings to be lost. To do this,
read the user's manual of your vehicle or ask the vehicle
manufacturer.
Disconnect the battery. Look for the positive and negative cable for
the backup light. Connect the red positive cable of the transmitter
with the aid of the clamp connector. Item 7 in the overview, with the
positive cable of the backup light. Connect the black negative cable of
the transmitter to the negative cable of the backup light. Proceed as
shown in Figures 4 to 6.
Positive cable
Backup light
Figure 4: Inserting the cable
Figure 5: Pressing in the small
contact plates
If you are unsure during the electrical installation, ask a
specialist workshop for advice.
There is a risk of personal injury and property damage.

6.2.6.1 CONNECTING THE CAMERA ON VEHICLES WITH CAN

BUS OR DATA BUS SYSTEM

For vehicles with CAN bus or other data bus systems, it may be
necessary to connect the transmitter using a 12 V working current
relay (not included in the scope of delivery).
Connect the transmitter with the help of the working current relay
according to sketch 1.
10
Positive cable
Transmitter
Figure 6: Closing the
safety clamp
backup
lamp
Mass
Mass
Sketch 1: Connection working current relay

6.2.7 MOUNTING THE MONITOR

Insert the monitor fi xture of the monitor holder, position 10 in the
overview, see Figure 7, in the recess on the back of the monitor.
Slide the monitor completely on the fi xture, until the lock engages.
Insert the angle plug of the monitor connection cable, item 2 in the
overview, in the connection socket of the monitor, Figure 8.
Suction
foot
Tab
Clamping lever
Figure 7: Monitor holder
Connection slot
Figure 8: Connection slot
Fasten the monitor with the holder on the windscreen of your vehicle,
as shown in Figures 9 and 10.
Figure 9: Setting the holder
Permanent plus battery
Relay
Transmittler
to Camera
Fixing nut
Monitor fi xture
Lock
Figure 10: Holder tight