Mounting The Camera; Connecting The Camera - Eufab 16256 Anleitung

6.2.4 Mounting the camera

Connect the camera to the camera holders, item 9 in the
overview, refer to Figure 2. For this use the bolts, item 5
in the overview and the nuts, item 6 in the overview. Do
not tighten the bolts yet. Place the number plate or the
number plate holder on the camera holders. Align the
camera holders so that the fastening holes of the number
plate or the number plate holder can be used. During this
both number plate holders must be no further apart than
4 cm, Figure 3.
Now tighten the bolts.
The gasket, item 8 in the overview, has a collar on one
side. This collar must later lie on the outside of the vehicle
metal. Now insert the camera cable through the gasket
from the collar side. Now insert the camera cable with the
gasket through the hole behind the number plate. Set the
number plate or the number plate carrier on the camera
holders and mount this combination back on your vehicle.

6.2.5 Connecting the camera

Select a suitable installation location for the transmitter, item 11 in the overview. Here it is possibly necessary to remove
parts of the lining in the boot or in the passenger compartment of the vehicle. The installation location must not be too far
removed from the camera and the rear light, pay attention to the cable lengths. In addition the transmitter must be placed
as close as possible to the receiver (monitor), without metallic components, body metal, ribs and reinforcements being able
to negatively influence the radio transmission. Fasten the transmitter, e.g. with cable ties. Lay the cable so that it cannot be
bent, pinched or stretched.
Caution: For the next step, working on the electrical system of the vehicle, it is necessary to unclamp the battery.
This could cause, for example, the radio code, data of the on-board computer or other settings to be lost. To do this,
read the user's manual of your vehicle or ask the vehicle manufacturer.
Disconnect the battery. Look for the positive and negative cable for the backup light. Connect the red positive cable of the
transmitter with the aid of the clamp connector. Item 7 in the overview, with the positive cable of the backup light. Connect
the black negative cable of the transmitter to the negative cable of the backup light. Proceed as shown in Figures 4 to 6.
Positive cable
Backup light
Figure 4: Inserting the cable
If you are unsure during the electrical installation, ask a specialist workshop for advice.
There is a risk of personal injury and property damage.
12
Positive cable
Transmitter
Figure 5: Pressing in the small
contact plates
Figure 2: Mounting the camera
Figure 3: Camera holders spacing
Figure 6: Closing the safety clamp