Replacing The Fuse; Troubleshooting; Maintenance And Care, Storage; Notes Regarding Environmental Protection - Eufab 16256 Anleitung

6.4 Replacing the fuse

Turn the knurled screw at the tip of the 12 V connector of the monitor cable anti-clockwise until it is released from the
connector and it can be removed. The fuse is exposed and can be remove from the connector. Replace the fuse with another
of the same strength and screw the knurled screw back into the connector.
Fuse: 6.0 x 30 mm, F, 1 A, 250 V

6.5 Troubleshooting

The ignition of the vehicle and
the monitor are turned on,
reverse gear is engaged, but the
display remains dark. The blue
indicator light is not lit up
The ignition of the vehicle and
the monitor are turned on,
reverse gear is engaged, the
blue indicator light is lit up but
the display does not show an
image.
The image on the monitor
malfunctions.
The monitor does not display a
clear image.

7. Maintenance and Care, Storage

Before cleaning unplug the connection cable from the monitor. Clean the housing of the monitor with a soft, dry cloth. Do not
use any abrasive or solvent-based cleaning agents. Never allow liquids to ingress into the housing.
When not in use store the rear view camera system in a dry location. Do not expose the camera system to any strong
temperature fluctuations. The resulting condensation can damage the system.

8. Notes regarding environmental protection

gekennzeichnetes
Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be collected
Elektroprodukt darf nicht in
separately and disposed of in an environmentally responsible manner for recycling. Please contact your community
den Hausmüll geworfen
or city administration regarding disposal options for electrical and electronic scrap.
werden
14
ECE-Prüfzeichen
The plug of the monitor cable is not
plugged into the 12 V vehicle socket.
The fuse in the plug of the monitor cable
triggered and must be replaced
The fuse for the 12 V vehicle socket
triggered and must be replaced.
No radio connection could be made bet-
ween the camera and the monitor. The
cable of the camera and the transmitter
are not correctly connected or they came
apart.
The signal between the camera and the
monitor has interference from other radio
sources (e.g. cellphone, transmitter for
garage door opener).
The radio connection between the came-
ra and monitor is not strong enough to
transmit the signals without interference.
The camera lens is dirty.
Strong light is falling directly on the lens
of the camera.
Gebrauchsanleitung lesen
Insert the plug of the monitor cable into
the 12 V vehicle socket
Replace the fuse in the plug of the
monitor cable
Replace the fuse in the fuse box of the
vehicle
Check the correct connection of the
cable to the camera, transmitter and
backup light.
Switch off the radio transmission sources
or get away from these radio sources.
Change the position of the transmitter
so that the distance to the monitor
is smaller and no metallic obstacles
negatively influence the transmission.
Carefully clean the lens.
As soon as the strong incidence of light
is gone, the image quality is again ok.